The Segway® Personal Transporter x2 provides enhanced performance on varied terrain with minimal environmental impact. Featuring all-terrain tires, a robust fender design, lithium-ion batteries and specially tuned software, the rugged Segway x2 will go practically anywhere in the wild that you want to go, whether it's along nature trails, over hilly terrain or on the beach.
The Segway x2's low-pressure tires cushion the ride on bumpy surfaces and minimize trail impact, while a continuous center rib provides a smooth ride on paved surfaces. The increased track width increases stability on uneven ground, and the x2 happily navigates a variety of surfaces including sand, grass, gravel, dirt and pavement. Depending on local regulations, it may be possible to use the x2 on multi-use pathways but it is not intended for use on sidewalks or pedestrian walkways. Check out the Segway i2 for sidewalk use.
The x2 features Segway's new LeanSteer technology, as well as the wireless InfoKey controller. These advancements make the ride even more intuitive and exhilarating and provide interesting trip data so you can track your journey from start to finish. The long-lasting lithium-ion batteries support the power demands of the x2, while still providing up to 12 miles of off-pavement range (depending on terrain, riding style and payload).
The sturdy fenders on the x2 are designed to protect you from debris and to safeguard you during leaning turns. The aluminum fender frames feature built-in lift handles that help you (and a friend!) get a grip on the x2 for loading in and out of a vehicle. The fender frames serve as a base for carrying cargo and are compatible with Segway cargo plates and the Segway Hard Cases by Givi.
|12.5 mph / 20 km/h
|260 lbs / 118 kg
| 26.5 x 33 in / 67cm x 84 cm
|120 lbs / 54.4 kg
|Two Saphion® lithium-ion battery packs
Up to 12 miles / 19km off-pavement
|Two brushless, DC servomotors
10 in / 25 cm black aluminum wheels
7 in / 17.7 cm wide low-pressure tires
9.5 in (24.13 cm)
|4.5 in / 11.43 cm
|Wireless infokey controller
Top speed and turning rate
The maximum forward speed and turning rate of your Segway x2 can be set using the wireless InfoKey controller. The two settings are:
When stored and charged at room temperature, the Segway x2 can operate in environments ranging from 14º to 122º F / -10º to 50º C. Actual performance is dependent on battery temperature, terrain, riding style and payload.
The x2's enhanced-traction tires and wider track make it ideal for rugged terrain. The Segway x2's inertial sensors constantly monitor the rider's position relative to gravity. This allows the Segway x2 to adjust for changes in terrain while keeping the rider upright.
|TURNING RADIUS: ZERO
One characteristic of any person is the ability to turn in place without impacting any nearby person or object, something few vehicles can do. By balancing on a single axle, Segway x2 riders can also turn in place.
The Segway x2 comes standard with Saphion lithium-ion battery packs. The batteries are designed with on-board electronics that automatically monitor both the condition and temperature of the batteries. Batteries can be recharged by utilizing any 90 to 260 volt and 50 to 60 Hz AC outlet (typically accessible in most countries). A complete cycle charge will take eight to ten hours, about the cost of a newspaper. Li-ion batteries are designed for approximately 1000 full charge/discharge cycles.
Range, battery life and recharge times can be affected by
factors such as terrain, temperature, speed of operation,
rider weight and load, proper storage techniques and environmental
Redundant electrical systems
Robust mechanical systems
Safety is our top priority in both design and operation. To help ensure that both Segway x2 users and those near them remain safe, we built redundancy into the balancing and electrical systems. If any system begins operating at diminished capacity, the other is programmed to assume responsibility. This allows the Segway x2 to maintain balance and bring the rider to a safe stop.
The highest design standards were implemented in building the Segway x2's mechanical structures, and each part has been thoroughly tested and analyzed to ensure such high standards were met.